how to set up intex easy set pool filter

How to Set Up Intex Easy Set Pool Filter

Summer is the time for enjoying hot weather and sunny days. What better way to relax than swimming in an Intex Easy Set Pool? But before you can jump in, you have to properly set up the pool filter. Follow these simple steps to ensure your pool is clean and ready for summer fun.

Step One: Unpack Your Pool Filter

When you first get your Intex Easy Set pool filter, take it out of the box and ensure that you have all the pieces. The filter pump should come with hoses, clamps, and a manual instruction guide. Read through the guide before starting the installation.

Step Two: Choose a Location for Your Pool

Before choosing a location for your pool, it’s important to take into account several factors such as the terrain, the amount of shade, and access to a power source. Once you’ve chosen a level location with good drainage, you can begin setting up your pool.

Step Three: Lay Out the Pool Liner

The next step is to lay out the Intex Easy Set pool liner. Unroll the pool liner and place it in the location you’ve chosen for your pool. Make sure the ground is smooth and free of any rocks, sticks, or debris that could puncture the liner.

Step Four: Inflate the Pool Ring

After you’ve laid out the pool liner, it’s time to inflate the pool ring. You can use a manual or electric pump for this step. Inflate the pool ring until it’s firm to the touch but still flexible.

Step Five: Fill the Pool with Water

Once the pool ring is inflated, it’s time to fill the pool with water. Use a garden hose to fill the pool and make sure you don’t overfill it beyond the recommended water level. As the pool fills up, the pool liner will stretch and conform to the shape of the pool ring.

Step Six: Install the Filter Housing Unit

After your pool is filled with water, it’s time to install the filter housing unit. The filter housing unit is an important component that helps keep your pool water clean by removing debris and unwanted particles.

Step Seven: Connect the Hoses

Once you’ve installed the filter housing unit, it’s time to connect the hoses. To do this, you’ll need to attach one end of the hose to the inlet of the filter and the other end to the outlet. Make sure you tighten the clamps securely to prevent leaks.

Step Eight: Prime the Pump

After connecting the hoses, it’s time to prime the pump. This step is important to ensure that the pump is properly operating before you turn it on. To prime the pump, turn off the power and open the air release valve on the filter housing unit. Fill the filter casing with water, then close the valve and turn on the pump.

Step Nine: Let the Pump Run

After priming the pump, it’s time to let it run for at least eight hours. This will allow the filter to circulate the water and remove any debris or particles that may have accumulated in the pool. After eight hours, you can turn off the pump and check the filter cartridge to see if it needs cleaning or replacement.

Conclusion

Setting up your Intex Easy Set pool filter is a simple process that can be done in just a few steps. By following these nine easy steps, you’ll have a clean and refreshing pool that’s ready for summer fun. Remember to always read the instruction manual carefully and take safety precautions when working with electrical components. Enjoy your new pool!