Care and maintenance of the hair gatherer

When using the hair collector, the debris to be treated in the water enters the inner side of the filter screen from the inlet of the hair collector, enters the outer side of the filter screen after being filtered by the filter screen, and enters the pipeline system through the outlet. After the hair collector has been used for a period of time, due to the increased resistance of the clogging of the dirt, it is necessary to open the cover of the collector, take out the filter cartridge inside and clean it, and then continue to use it. 1. Cleaning method of the hair collector: (1) Close the water inlet and outlet valves of the hair filter tightly, and open the sewage outlet at the bottom.

(2) Use a wrench to open the bolts of the upper cover, remove the upper cover, and remove the inner filter basket. (3) Remove the impurities in the filter basket, wash the stolen goods hanging on it with water, and clean the sundries in the tank at the same time. (4) Install each part in turn, then open the valve of the main pipeline, open the air release valve on the top of the equipment to release air, and the hair collector can be restarted.

(5) The hair collector is generally cleaned once a month, or the cleaning cycle is determined according to the actual impurity content. Hair collector maintenance: (1) Pressure test: The pressure of the filter hydraulic test is 1.5 times of its design pressure, and the pressure holding time is 30 minutes to ensure that there is no penetration and deformation. (2) After the filter works for a period of time, certain impurities are deposited in the filter element. At this time, the pressure drop increases and the flow rate will decrease. It is necessary to remove the impurities in the filter element in time.

(3) The core part of the filter is the filter element. The filter element is composed of a filter frame and a stainless steel wire mesh. The stainless steel wire mesh is a vulnerable part and needs special protection. (4) If the stainless steel wire mesh is found to be deformed or damaged, it must be replaced immediately. (5) When cleaning impurities, pay special attention to the fact that the stainless steel wire mesh on the filter element cannot be deformed or damaged, otherwise, the purity of the filtered medium will not meet the design requirements, and compressors, pumps, instruments and other equipment will be damaged. been destroyed.

The Boying hair collector is an essential equipment for the circulating water treatment system. The turbid water in the swimming pool is mixed with a large amount of sediment, stones, debris, hair, etc., which are pumped out by the water pump and first intercepted and collected by the hair collector. The effect of flow and interception not only affects the life of the water pump, but also has a great impact on the filtered water quality of the water purifier. Poolking is the best swimming pool equipment manufacturer and supplier in China. Poolking exists to provide the highest quality swimming pool equipment while offering competitive pricing..