How To Own swimming pool booster pump For Free

----Yes, they can. Silica sand is mainly used for filtration, while activated carbon is mainly used for adsorption. Silica sand is effective for higher water quality requirements. When use them together, silica sand should be placed on the bottom layer, and then activated carbon should be filled on the sand, but the cost of using two media is much higher.

Bigger is not always better when it comes to pool pumps. A pool pump that is too large can hinder filtration and can even damage a pool’s filter and/or heater. It is therefore very important to know the size of a pool before purchasing a pool pump. If there is additional equipment (such as water features) installed into the pool, it will have to be taken it into account when deciding what size pump is going to be purchased. The more equipment is installed into a pool, the more powerful the pump needs to be.
It is important to consult with a pool equipment expert, such as Poolking's Pumps, before buying a pool pump. The team at Poolking will be able to give our customers professional advice regarding the size of the pump they will need to purchase.

After about 5~10days ,or when the reading of the pressure gauge on the pump side of the filter has increased by about 0.2bars since the last backwash , backwash the filter as follows:
1. Stop the pump
2.Close the valves on the suction and return lines.
3.Open the cover of the pump and empty the filter gasket .
4.Refit the cover
5.Open the valve to the drain outlet
6.Turn the lever to BACKWASH
7. Open the valves to the suction and return lines.
8.Start the pump .Rinse the filter for about 1 to 2 minutes until the water in the sight glass is clear .
NOTE : Any electric heater must be off .
9. Stop the pump
10. Turn the lever to RINSE , start the pump and rinse for about 15~30 seconds. Stop the pump and turn the lever to FILTER . This is the normal operating position .
11. Close the drain outlet valve and start the pump . Switch on the electric heater if any .