how to make a pool filter pump

Author: PoolKing - Pool Sand Filter Manufacturers

Pool Filter Pump: A Step by Step Guide on How to Make Your Own

If you have a pool, then you should know that a pool filter pump is a must-have to keep your pool water clean and free from impurities. While it’s easy to buy a pool filter pump from the store, it can be quite expensive. But did you know that you can make your own pool filter pump using some tools and materials that you can easily find in your local hardware store? In this article, we’ll guide you on how to make your own pool filter pump in simple steps and under a budget.

Materials Needed

Before you can start making your own pool filter pump, you’ll need to gather some materials. These include:

- PVC pipes (2-3 inches in diameter)

- PVC elbows (2-3 inches in diameter)

- PVC adaptors (2-3 inches in diameter)

- A pool pump

- A pool filter

- Silicon caulk

- Hose clamps

- A hacksaw

- A drill

- A screwdriver

- Sandpaper

- Teflon tape

Step 1: Measure the Pipes

The first thing you need to do is to measure the distance between your pool pump and filter. You’ll need to cut two PVC pipes that will connect the pool pump and filter. Measure the distance using a measuring tape and mark the two points where you will place the PVC elbows.

Step 2: Cut and Assemble the Pipes

Using a hacksaw, cut the PVC pipes to the desired length. Then, use the PVC elbows to connect the pipes. Fit the PVC adaptors on both ends of the pipes.

Step 3: Drill Holes on the Adaptor

Make sure that the adaptor is securely attached to the PVC pipe. Then, using a drill and a small drill bit, drill small holes around the adaptor. These holes will allow water to flow in and out of the filter pump.

Step 4: Attach the Hose Clamps

Using a screwdriver, attach the hose clamps on both ends of the PVC pipes. This will keep the pipes in place and prevent them from getting detached from the pool pump and filter.

Step 5: Connect the Pool Pump and Filter

Insert the PVC pipes into the pool pump outlet and filter inlet. Ensure that the adaptor is secured, and the hose clamps are tightened. Use Teflon tape to seal the connections.

Step 6: Check for Leaks

Turn on the pump and check for leaks. If there are any leaks, use silicon caulk to seal them.

Conclusion

In conclusion, making your own pool filter pump can be easy and cost-effective. With the right tools and materials, you can make a pool filter pump that is durable and efficient. Follow the simple steps above and enjoy clean and refreshing pool water all summer long.

Subtitles:

- Introduction

- Materials Needed

- Step 1: Measure the Pipes

- Step 2: Cut and Assemble the Pipes

- Step 3: Drill Holes on the Adaptor

- Step 4: Attach the Hose Clamps

- Step 5: Connect the Pool Pump and Filter

- Step 6: Check for Leaks

- Conclusion