how to connect pool filter pump

How to Connect Pool Filter Pump: A Comprehensive Guide

If you're a proud owner of a personal pool, you understand the significance of maintaining it in tip-top shape. One of the most essential parts of the pool's upkeep is keeping the water clean, and that's where the pool filter pump comes in. Connecting your pool filter pump might be a daunting task, especially for beginners, but fear not. This guide will walk you through the process, leaving you with clean and healthy pool water.

What you will need:

- Pool filter pump

- Pool filter cartridges

- PVC pipes and fittings

- Teflon tape

- Screwdriver

- Pipe wrench

- Rubber mallet

Step 1: Take Inventory and Gather Your Supplies

Before starting the installation process, make sure you have all the necessary supplies to connect your filter pump. The last thing you want is to be halfway through the process, and you realize you're missing a crucial element. You need to make sure you have your pump, cartridges, PVC pipes, fittings, Teflon tape, screwdriver, pipe wrench, and rubber mallet.

Step 2: Read the Instruction Manual

This step might seem basic, but most individuals disregard it altogether. Reading the instruction manual is critical as it equips you with an overview of the installation process. Every pool filter pump can be slightly different, and the manual helps you understand the workings of that specific pump.

Step 3: Install PVC Pipes

The PVC pipes supply water from the pool to the pump and back to the pool after filtration. First, measure the distance between the pump and filter, then cut the PVC pipes to size. You will also need to measure the diameter of the PVC pipes at the pump's inlet and outlet. Once you've ascertained this, add 1 inch to both measurements, and cut four PVC pipes into the required sizes. Secure the pipes to the pump using PVC fittings and Teflon tape to seal the connection.

Step 4: Prepare the Filter Cartridges

This step depends on the type of filter cartridges you have. You may either have disposable filters or reusable ones. In case you have disposable filters, take one and check if you need to install any internal parts before setting up the cartridge. Once you've confirmed everything is in place, insert the filter cartridge into the filter.

Step 5: Connect the Pool Skimmers to the Filter

Once the PVC pipes are securely attached to the pump and filter, the next step is to connect the pool skimmers to the filter pump. There should be an inlet valve on the filter pump, and you need to attach the PVC pipe with the skimmer basket to it. Use a pipe wrench to tighten the PVC fitting in place.

Step 6: Connect the Filter Outlet to the Pool

The pool filter pump processes the pool water and pumps it out to the pool. Using the same process for connecting the skimmer to the pump, attach the pump's outlet pipe to the pool's inlet. Use Teflon tape to prevent water from leaking out of the connection points.

Step 7: Test the Connections

You need to ensure that all connections are secure and that there are no leaks in the PVC pipes or fittings. Turn on the pool pump and let it run for a while, then check if water is flowing correctly through the system. If there are no leaks, you may close the filter pump and allow it to perform its job.

In Conclusion

Connecting a pool filter pump might seem challenging, but with the right tools and a little bit of patience, you can do it yourself. The steps outlined above provide a guide on how to connect your pool filter pump to ensure clean and healthy pool water all season. Remember to read the instructions carefully and take your time as you work through the process.