how to change sand in pool filter youtube

Author: Poolking - Swimming Pool Equipment Manufacturer

How to Change Sand in Pool Filter: A Complete Guide

A pool filter is one of the essential components of a swimming pool. It helps to keep the water clean, clear, and safe. However, like any other filter, it needs occasional maintenance to work effectively. One of the significant steps you can take to keep your pool filter functional is by changing the sand regularly. In this article, we will guide you through the process of changing sand in pool filter YouTube.

What You Will Need

Before we begin, let us take a look at the tools you will need for this task.

- A pool filter sand removal kit

- New pool filter sand

- A garden hose

- A bucket

- A screwdriver

- A hand-held shop vac

- Teflon tape

Step 1: Turn off the Pool Pump

Before you start working on the pool filter, ensure that the pool pump is turned off. This step is crucial since it will prevent any accidents from occurring. You do not want water rushing in or out of the filter while you are working.

Step 2: Release Pressure from the Filter

To release the pressure from the filter, you will need to unscrew the air bleeder valve found at the top of the filter. Then, open the drain plug at the bottom of the filter to let the water out.

Step 3: Remove the Old Sand

To remove the old sand, you need to use a pool filter sand removal kit. Use the vacuum in the kit to suction the sand out of the filter's tank. Ensure that you remove all the sand until the filter's laterals or fingers are exposed.

Step 4: Clean the Laterals

Once you have removed all the sand from the filter, it is time to clean the laterals. Rinse them with a garden hose to remove any debris, dirt, or small bits of sand.

Step 5: Fill the Filter Tank

Once you have cleaned the laterals, fill the filter tank one-third of the way with water. Then, pour the new pool filter sand into the tank. Be sure to distribute it evenly.

Step 6: Reassemble the Filter

After pouring the sand, it is time to reassemble the filter. First, replace the laterals or fingers. Then, screw back the air bleeder valve and tighten the drain plug firmly.

Step 7: Backwash the Filter

You must backwash the filter to remove any debris left over from the sand change process. Backwashing entails turning on the pool pump and setting the valve to the backwash position. Let the pump run for about two minutes or until you can see clear water coming out of the waste pipe.

Step 8: Rinse and Return to Filter Position

Once you have backwashed, turn off the pool pump, set the valve to rinse, and turn the pump on again for about a minute. Finally, turn off the pool pump and set the valve back to filter.

Step 9: Check for Leaks

Check the filter for any leaks. Turn on the pool pump and watch the pressure gauge. If you notice any leaks, turn off the pool pump immediately and tighten the leaking parts with Teflon tape.

Conclusion

Changing sand in pool filter YouTube is a simple process that you can do by yourself with the right tools and knowledge. By following the above nine steps, you can keep your filter in top condition and maintain your pool water's cleanliness and clarity. Remember to replace your sand every three to five years, depending on your pool usage. Happy swimming!