Here's What People Are Saying About skimmer sock

a. Power failure or motor protection tripped
b. Pump doesn't vent
c. Pump doesn't fill the water
d. Suction line/hose leaking
e. Transparent cover not properly installed - check filter basket - even bolts
f . Inlet suction process is too large g.) Total resistance loss exceeds the allowable range of the pump - recalculate the required pressure
h. Mechanical shaft seal leakage

----Poolking utilize serval world class production machines to produce the products, and strict quality control system for each products. It treats a small flaw with zero tolerance.
Not only good quality products, but also fast and satisfying after sales service for clients. Let the clients enjoy the clear water and comfortable services.
If Poolking’s products are same quality than others but higher prices, how can Poolking survive ? However Poolking can defeat other players and seize more market share.
Poolking is your best choice!

After about 5~10days ,or when the reading of the pressure gauge on the pump side of the filter has increased by about 0.2bars since the last backwash , backwash the filter as follows:
1. Stop the pump
2.Close the valves on the suction and return lines.
3.Open the cover of the pump and empty the filter gasket .
4.Refit the cover
5.Open the valve to the drain outlet
6.Turn the lever to BACKWASH
7. Open the valves to the suction and return lines.
8.Start the pump .Rinse the filter for about 1 to 2 minutes until the water in the sight glass is clear .
NOTE : Any electric heater must be off .
9. Stop the pump
10. Turn the lever to RINSE , start the pump and rinse for about 15~30 seconds. Stop the pump and turn the lever to FILTER . This is the normal operating position .
11. Close the drain outlet valve and start the pump . Switch on the electric heater if any .