how to change sand in a pool filter videos

Author: Poolking - Swimming Pool Equipment Manufacturer

How to Change Sand in a Pool Filter Videos: A Step-by-Step Guide

If you have a swimming pool in your backyard, you know that keeping it clean and maintained is essential. One of the most crucial components of a pool is the filter, which helps to keep the water clear and free of debris. Over time, the sand in your pool filter can become clogged with dirt and other particles, reducing its effectiveness. In this article, we’ll walk you through the process of changing the sand in your pool filter so that you can keep your pool in tip-top shape.

What You’ll Need:

Before we get started, here’s a list of the tools and materials you’ll need to complete the job:

1. Screwdriver

2. Pool filter sand

3. Pool filter cleaner

4. Bucket

5. Garden hose

6. Pool filter wrench (optional)

7. Pool gloves

Subheading 1: Preparing Your Pool Filter for Sand Replacement

The first step is to turn off the pool pump and drain the water from the filter. Once the filter is empty, remove the top of the filter by unscrewing the clamp band. If your filter has a multiport valve, you’ll need to remove it from the filter before you can remove the sand.

Subheading 2: Removing the Old Sand

Now that the filter is open, you can remove the old sand. Using a screwdriver, loosen the bolts that hold the filter bottom to the tank. Once you’ve done this, you can lift the filter bottom up and out of the tank. Dump the old sand into a bucket or onto a tarp, being careful not to spill it on the ground or in the pool. If you notice any cracks or damage to the filter laterals or pipes, this is the time to replace them.

Subheading 3: Cleaning the Filter Tank

With the old sand removed, it’s time to clean the filter tank. Using a pool filter cleaner, spray the inside of the tank and all the parts. Use a garden hose to rinse away the debris and excess cleaner. If the buildup is particularly stubborn, you may need to use a pool filter wand to scrub away the grime.

Subheading 4: Adding the New Sand

Once the tank is clean and dry, it’s time to add the new sand. It’s important to choose the right type of sand for your filter and to use the correct amount. Check your pool filter manufacturer’s instructions to find out the right amount of sand to use.

Using a funnel, add the sand to the filter. Be sure to pack it down firmly as you add it, to avoid any gaps or spaces between the sand. When the sand level reaches the fill line, replace the filter bottom and bolt it back in place. Make sure the tank is securely fastened, and then reattach the multiport valve if you removed it.

Subheading 5: Starting up Your Filter

With the tank full of new sand, it’s time to start up your filter again. Make sure the pump is off and set the multiport valve to “filter” or “backwash." Turn the pump back on and let it run for a few minutes to remove any air in the system. Then, turn the pump off again and set the multiport valve to “rinse.” Turn on the pump again and let it run for a minute or two to clear out any debris or sand that may have gotten into the system.

In Conclusion:

Changing the sand in your pool filter can seem like an intimidating task, but with a little bit of know-how, it’s a job that you can handle on your own. Make sure to take the time to properly prepare your filter, remove the old sand, clean the tank, add the new sand, and start up your filter again. Once you’ve completed these steps, you’ll be able to enjoy clear, sparkling water in your swimming pool all summer long.