how to get air out of pool filter system

Author: PoolKing - Pool Sand Filter Manufacturers

Introduction:

Maintaining a pool is not an easy task, and it takes a lot of effort and time to keep it clean and clear. Pool filters play an important role in this regard as they keep the pool water free of debris and impurities. However, air trapped in the pool filter system can lead to various problems such as decreased filter efficiency, reduced water flow, and even damage to the filter equipment. Therefore, it is crucial to learn how to get air out of the pool filter system to ensure proper functioning and longevity of the pool filter.

Subheading 1: Why is air in the pool filter system a problem?

Air can enter the pool filter system due to various reasons such as leaks, clogged skimmer baskets, or backwashing the filter without properly venting the air. Once air gets trapped in the filter, it can cause several problems. It can reduce the flow of water, making the pool water cloudy and dirty. Air bubbles can also be released into the pool, making it noisy and uninviting. Additionally, air can cause the pump to overheat and, if left unchecked, can even damage the filter equipment.

Subheading 2: How to check for air in the pool filter system?

To check for air in the pool filter system, you can perform a simple test. First, turn off the pool pump and let the water settle. Then, turn on the pump and observe the water flow. If you notice air bubbles coming out of the return jets, it means air is present in the pool filter system. Another way to check for air is to look for water leaks or hissing sounds around the filter, pump, or plumbing connections.

Subheading 3: How to bleed air out of the pool filter system?

The process of bleeding air out of the pool filter system is called priming, and it involves removing air pockets from the plumbing lines and the filter equipment. Here are the steps to do it:

Step 1: Turn off the pool pump and any other pool equipment that draws water, such as heaters, cleaners, or water features.

Step 2: Clean or replace the skimmer basket and remove any debris or leaves that may be clogging the basket.

Step 3: Remove the air relief valve or pressure gauge from the pool filter to release any air trapped inside.

Step 4: Turn on the pool pump and let it run for a few seconds to allow water to circulate.

Step 5: Slowly open the air relief valve or pressure gauge until you see water coming out of the filter. This will release any remaining air trapped in the pool filter system.

Step 6: Once all air is released, close the air relief valve or pressure gauge and turn on any other pool equipment that draws water.

Subheading 4: How to prevent air from getting into the pool filter system?

Preventing air from entering the pool filter system is essential to avoid future problems. Here are some tips to help you keep the pool filter system free of air:

Tip 1: Check the skimmer basket regularly and clean or replace it if necessary. A clogged skimmer basket can prevent water from flowing freely through the system.

Tip 2: Check the pool pump lid and O-ring for any cracks or wear and replace them if needed. A damaged pump lid or O-ring can allow air to enter the filter system.

Tip 3: Check the pool plumbing connections for any leaks or loose fittings and tighten them if necessary. Leaks can allow air to enter the filter system.

Subheading 5: Conclusion

Removing air from the pool filter system is crucial for maintaining proper pool function and longevity. The priming process involves removing air pockets from the plumbing lines and the filter equipment. It is also important to prevent air from entering the filter system by checking the skimmer basket, pump lid, O-ring, and plumbing connections regularly. By following these tips, you can enjoy a clean and clear pool without any air-related problems.