how to make your own pool filter

Author: PoolKing - Pool Sand Filter Manufacturers

Pool filters play a vital role in keeping pools clean, safe, and healthy for swimmers. They remove contaminants from the water, ensuring that the pool remains crystal clear, so it is essential to have a reliable filter in your pool. Fortunately, you don't have to break the bank to get a good pool filter; you can make your own pool filter with some basic tools and materials.

In this article, we'll walk you through the steps to make your pool filter, from gathering the necessary supplies to assembling the filter. You'll be shocked at how simple it is to make a DIY pool filter.

What You Need

Before we dive into the steps, let's go through the materials you will need. Here are the things you will need:

1. Five-gallon bucket

2. PVC pipes

3. PVC valvular pipe

4. Sand

5. Gravel

6. Drill

7. Hole saw

8. Silicone

9. Saw

10. Tape measure

The Steps to Building Your Pool Filter

Now that you have collected all of your supplies let's build your pool filter. To build your pool filter, follow these easy steps:

Step 1: Cut the Holes in the Bucket

Start by drilling two holes into the bottom of the five-gallon bucket. The holes should be six inches apart from each other, and the drill bit must be the same size as the PVC pipes.

Step 2: Install the Pipes

Install the PVC pipes into the holes that you just cut and secure them using silicone. You should use as much silicone as necessary to make sure that the pipes are firmly held in place.

Step 3: Cut the PVC Valvular Pipe

Cut the PVC valvular pipe to the desired length. Make sure you don't cut the valvular pipe too short or too long so that it can still fit perfectly inside the bucket.

Step 4: Prepare the Sand and Gravel

Fill a container with sand and gravel in the same ratio using a tape measure or weight scale. We recommend using about 50% sand and 50% gravel in your homemade pool filter.

Step 5: Layering the Sand and Gravel

Pour the sand and gravel into the bucket, in layers. Make sure to start with the gravel at the bottom, followed by the sand.

Step 6: Cover the PVC Pipe

Cover the PVC pipe on top of the sand with a plastic or other material. The cover should be sturdy enough to prevent sand from entering the PVC pipe.

Step 7: Insert the PVC Valvular Pipe

Insert the PVC valvular pipe into the center of the bucket using the silicone, make sure it is secure.

Step 8: Install PVC Cap

Install a PVC cap at the end of the PVC valvular pipe. The PVC cap should fit perfectly onto the pipe.

Step 9: Put the Filter in Your Pool

Now that you are done making your pool filter, it is time to put it to use. Place the filter in your pool, ensuring that the PVC pipes are above the waterline.

Maintaining Your Homemade Pool Filter

Like any other pool filter, your homemade pool filter will require maintenance to keep it working correctly. You'll need to backwash the filter occasionally to remove dirt and debris. Also, it would be best if you replaced the sand and gravel every two years.

Conclusion

In conclusion, making your pool filter doesn't have to be complicated or expensive. As we have seen, you can make a homemade pool filter quite easily with some tools and materials. It is an excellent way to save on money and keep your pool clean and sparkling. With regular maintenance, you can enjoy a clean and refreshing swim all summer long.