how to turn on the pool filter

Author: PoolKing - Pool Sand Filter Manufacturers

How to Turn on the Pool Filter

If you own a pool, one of the most important things you need to know is how to turn on the pool filter. A pool filter is an essential piece of equipment that helps clean the water in your pool by removing dirt, debris, and other particles. Without a properly functioning filter, your pool water can quickly become dirty and unsafe for swimming.

In this article, we’ll show you how to turn on your pool filter step-by-step, so you can enjoy a clean and safe swimming experience all summer long.

1. Check the Pressure Gauge

Before turning on the pool filter, it’s important to check the pressure gauge. The pressure gauge is a small gauge that’s located on the filter tank. It measures the pressure inside the tank and indicates when it’s time to backwash or clean the filter.

If the pressure gauge reads above 30 PSI, it’s time to clean or backwash the filter. If the gauge reads below 30 PSI, you can proceed with turning on the filter.

2. Turn on the Filter Pump

The next step is to turn on the filter pump. The filter pump is a large motor that powers the filter system. It’s typically located near the filter tank and has an on/off switch.

To turn on the filter pump, simply flip the switch to the “on” position. You should hear the motor start to run, and water should begin flowing through the system.

3. Adjust the Skimmer and Return Valves

After turning on the filter pump, you’ll need to adjust the skimmer and return valves. The skimmer valve controls the amount of water that flows into the filter system, while the return valve controls the amount of clean water that returns to the pool.

You’ll want to adjust both valves to ensure proper water flow. The skimmer valve should be opened fully to allow as much water as possible to flow into the system. The return valve should also be adjusted to allow proper water flow back into the pool.

4. Monitor the Filter System

Once the filter system is turned on and properly adjusted, you’ll want to monitor it for a few hours to ensure everything is working properly. You should see water flowing through the system and debris beginning to collect in the filter tank.

If you notice any issues, such as low water flow or a noisy motor, it’s important to address them right away.

5. Clean or Backwash the Filter

Finally, you’ll need to clean or backwash the filter on a regular basis to keep the system working properly. The frequency of cleaning or backwashing will depend on the size of your pool and how often it’s used.

To clean or backwash the filter, simply turn off the filter system and follow the manufacturer’s instructions for cleaning. This may involve removing the filter tank, hosing it down with water, or using a special cleaning solution.

Conclusion

Now that you know how to turn on the pool filter, you can enjoy a clean and safe swimming experience all summer long. Remember to check the pressure gauge, adjust the skimmer and return valves, and monitor the filter system regularly. With proper maintenance and care, your pool filter should last for many years to come.