how to install pool filter grids

Author: PoolKing - Pool Sand Filter Manufacturers

How to Install Pool Filter Grids

Swimming pools are a great addition to any household, especially during the hot summer months. However, keeping the pool clean and clear of debris is essential to ensure that you and your family have a safe and enjoyable swimming experience. This is where pool filter grids come in handy. These grids work to filter out small particles of dirt and debris from your pool water, ensuring that your pool stays crystal clear. In this article, we will guide you through the process of installing pool filter grids, step-by-step.

1. Gather the Necessary Tools

Before starting the installation process, it's essential to ensure that you have all the necessary tools and equipment to get the job done correctly. You'll need a pool filter grid, a filter tank, a wrench, a screwdriver, and Teflon tape. Familiarize yourself with the manual that came with your pool filter to ensure that you have everything you need.

2. Turn Off the Power

Ensure that the power to your pool pump is switched off before starting any installation processes. This is to prevent any electrical hazards while working with the pool filter.

3. Detach the Pool Filter Tank

Next, use a wrench to loosen the band clamp holding the pool filter tank in place. Once the clamp is off, you can easily remove the filter tank. Keep the multiport valve attached to the filter and set the tank aside.

4. Remove the Old Pool Filter Grids

With the tank removed, you can now access the internal components of your pool filter. The grids are located towards the bottom of the filter, and it might be necessary to remove the internal standpipe first. Once the standpipe is removed, you can easily pull the old filter grids out of the tank.

5. Install the New Pool Filter Grids

It's now time to install the new pool filter grids. Ensure that the grid is placed correctly according to the orientation indicated. Gently lower the new grids into the tank, making sure that they are aligned correctly. Once the grids are in place, you can re-install the standpipe if it was removed earlier.

6. Re-assemble the Pool Filter Tank

It's time to re-assemble everything back together. Tighten the clamp band to secure the filter tank firmly in place. Ensure that you follow the instructions outlined in the manual to ensure that everything is assembled correctly.

7. Turn the Power Back On

Once you are satisfied that everything is correctly put together, it's time to switch the power back on. Turn on the pool pump and let it run for a few minutes to circulate the water through the new filter grids.

Conclusion

Installing pool filter grids might seem like a daunting task, but it is relatively easy with the right tools and instructions. By following the steps outlined above, you can ensure that your pool is always clean and clear, making it an enjoyable experience for you and your family. Always remember to follow the instructions outlined in the manual to avoid any mishaps during the installation process. With these helpful tips, you're good to go!