how to turn a pool filter on

Introduction:

If you have a pool in your backyard, you must have a pool filter. It keeps the pool water clean by removing dirt and debris from the water. However, turning on a pool filter for the first time can be a daunting task, especially if you are new to pool ownership. In this article, we will show you how to turn on a pool filter step by step.

Subheading 1: Know the Parts of a Pool Filter

Before you start turning on your pool filter, you must understand the different parts of a pool filter. A pool filter consists of three main parts: the pump, the filter tank, and the filter element. The pump is responsible for drawing water from the pool and sending it to the filter tank. The filter tank, which contains the filter element, filters out debris from the water. The filter element is the component that traps debris from the water.

Subheading 2: Pre-Check the Pool Equipment

Before you turn on the pool filter, ensure that all the equipment, including the valves and pipes, are connected correctly. Check for any leaks, cracks, or damages, and have them repaired before turning on the filter. Also, ensure that the pool's water level is high enough to cover the skimmer inlet.

Subheading 3: Prime the Pool Pump

The next step is to prime the pool pump. Priming your pool pump is necessary as it ensures that the pump is full of water and lubricated, preventing dry running that can cause damage to the system. Priming is easy; locate the pool pump's basket lid, remove it, and fill the basket with water until it overflows. Replace the lid and ensure that it is tight.

Subheading 4: Set the Pool Filter's Valve

Next, you need to set the pool filter's valve to the correct position. The valve has three positions: filter, backwash, and waste. The filter position is the most commonly used setting, and it allows water to pass through the filter. The backwash setting allows water to flow in the opposite direction, flushing dirt and debris out of the filter. The waste setting bypasses the filter and allows water to flow straight to the sewer. To set the valve, turn it to the filter position.

Subheading 5: Turn on the Pool Filter

To turn on the pool filter, locate the switch or timer that controls the pool pump. Turn the switch to the "on" position or set the timer to the desired time. The pool filter will start running, and you will be able to see the water flowing from the pool to the filter and back to the pool.

Conclusion:

Turning on a pool filter for the first time can be challenging, but if you follow the steps outlined above, it should be a breeze. Remember to pre-check the equipment, prime the pool pump, set the filter valve to the correct position, and turn on the filter. By doing so, you will have crystal clear water in your pool all season long.