how to set up an intex pool filter

Whether you are planning a backyard pool party or simply want to cool off on a hot summer day, having an Intex pool filter can make a world of difference when it comes to keeping your pool clean and clear. Not only does it help to remove debris, but it also helps to circulate the water and maintain the proper balance of chemicals.

If you're new to Intex pools or are unsure how to set up a filter system, don't worry. In this guide, we'll walk you through the process step by step so you can start enjoying your pool in no time.

1. Gather Your Supplies

Before you begin, you'll need to gather all the necessary supplies. This includes:

- Intex pool filter

- Filter pump

- Hoses

- Plunger valves

- Pool skimmer

- Pool vacuum

Make sure all of the components are in good condition and free from any damage or cracks. If you notice any issues, contact Intex customer service to request a replacement.

2. Choose the Right Location

The next step is to choose the right location for your filter system. Ideally, the filter and pump should be positioned on a flat, level surface within 5 feet of the pool. This will help to ensure proper water flow and prevent any damage or leaks.

3. Connect the Hoses

Once you have the right location, it's time to connect the hoses. There are typically two hoses that come with the Intex pool filter – one for inflow and one for outflow. You'll need to attach these hoses to the pool's inlet and outlet ports, respectively.

Before attaching the hoses, make sure they are free from any twists or kinks that could impede water flow. Then, use the plunger valves to connect the hoses to the filter and pump.

4. Install the Skimmer and Vacuum

In addition to the filter system, you'll also need to install the pool skimmer and vacuum. The skimmer is used to remove debris from the surface of the water, while the vacuum is designed to clean the bottom of the pool.

To install the skimmer, simply attach it to the side of the pool using the provided clips or screws. Then, connect the skimmer hose to the inlet port on the filter pump.

To use the vacuum, attach it to the outflow hose on the filter pump. Then, insert the vacuum head into the pool and slowly move it across the bottom to remove any debris.

5. Prime the Pump

Before turning on the filter pump, you'll need to prime it to ensure proper water flow. To do this, fill the filter housing with water and turn on the pump. Allow it to run for a few minutes, then check the water flow and pressure gauge to ensure it is operating correctly.

In Conclusion

Setting up an Intex pool filter may seem intimidating at first, but with a little patience and know-how, it's a task that can easily be accomplished. By following these five steps, you'll have your filter system up and running in no time, leaving you with a clean and enjoyable pool all summer long.