how to install polygroup pool filter

How to Install Polygroup Pool Filter

Installing a pool filter is essential in keeping your pool clean and safe for swimming. A quality pool filter should be able to efficiently filter out dirt and debris, as well as keep the water free of harmful bacteria. The Polygroup pool filter is a popular choice for its durability and effectiveness. Here’s a step-by-step guide on how to install the Polygroup pool filter.

1. Unpack the Polygroup Pool Filter

Before you begin the installation, ensure that all the parts are included in the package. This will save you from any potential headaches during the installation process. The Polygroup pool filter comes with a pump/filter assembly, hoses, clamps, and adapters. Double-check that all parts are included before proceeding.

2. Choose the Right Location for the Polygroup Pool Filter

The Polygroup pool filter should be placed on a level surface that can support its weight. Ideally, the filter should be near the pool, but not too close as it can obstruct the pool area. Make sure that there is enough space around the filter for maintenance, repair, and cleaning.

3. Connect the Hoses

The Polygroup pool filter comes with hoses that connect the pump and filter to the pool. Make sure that the hoses are properly connected to the filter and the pool. The hoses should fit snugly, and the clamps should be tightened securely to prevent leaks.

4. Attach the Adapters

The Polygroup pool filter comes with adapters that allow you to connect the hoses to the pool, and the pump/filter assembly. Attach the adapters to the hoses, making sure that they are securely in place. If the adapters are loose, this may cause leaks, and compromise the effectiveness of the filter.

5. Fill the Pool with Water

Before turning on the pump, fill the pool with water until the water level is above the water intake of the pool filter. This allows the pump to have an adequate supply of water to filter. If the pool water level is too low, this can cause damage to the pump.

6. Turn on the Pump and Check for Leaks

After filling the pool with water, turn on the pump and filter. Observe the Polygroup pool filter for any leaks or abnormal noises. If there are leaks, turn off the pump and tighten the hoses and clamps until the leak is resolved.

7. Run the Pump and Filter Regularly

To keep the pool clean and safe for swimming, the Polygroup pool filter should be run regularly. This helps to prevent the build-up of dirt and debris in the pool. The recommended running time of the pump varies depending on the pool size, but it's usually about 8 hours per day.

In conclusion, installing a Polygroup pool filter is a great investment in your pool and your family's health. Follow these steps to ensure that your Polygroup pool filter is installed properly and working effectively. Remember to run the pump and filter regularly, to keep the pool clean and safe for swimming.