how to connect the pool filter

Author: PoolKing - Pool Sand Filter Manufacturers

.

If you have recently installed a pool in your backyard, the next step is connecting the pool filter to keep your water clean and clear for safe swimming. It may seem like a complicated task, but with proper guidance, you could easily do it yourself. This article offers a comprehensive guide on how to connect the pool filter.

Understanding Your Filter System

To begin with, you need to understand your pool's filter system. Depending on the type of pool you have, you may have a sand, cartridge, or diatomaceous earth (DE) filter. You should also locate the filter system and identify the different parts.

- Sand Filter

A sand filter consists of a tank filled with sand and a series of pipes that direct water through the sand. The sand filters the water, trapping dirt and debris, and releasing clean water back into the pool.

- Cartridge Filter

A cartridge filter is a replaceable filter element that traps debris and dirt as water passes through it. It requires less maintenance than a sand filter and is ideal for small to mid-sized pools.

- DE Filter

A DE filter is similar to a sand filter, except the tank is filled with a fine powder of crushed diatom shells. The DE powder coats the grids within the filter, trapping dirt and debris.

Connecting Your Filter System

Now that you understand the different types of filter systems let's look at how to connect them to your pool.

Step 1: Turn off the Pool Pump

Before you start any installation process, ensure you turn off the pool pump to avoid accidents.

Step 2: Connect the Filter System

Each pool filter system comes with different components but typically should include the following:

- Pump

- Filter

- Flexible hoses for connecting the pump and filter

- Clamps for securing the hoses in place

Connect the hoses between the pump and filter by sliding one end over the discharge port of the pump and the other end over the intake port of the filter. Use a clamp to secure each hose end in place.

Note: For DE filter systems, the hoses will connect to the multiport valve, not the filter.

Step 3: Connect the Skimmer to the Pump

The skimmer is a vital part of the pool filtration system. It collects debris and dirt from the water's surface, directing it to the pump and filter for cleaning. Here are simple steps to connect the skimmer to the pump:

- Attach a flexible hose to the intake port of the pool skimmer.

- Connect the other end of the hose to the suction port of the pool pump.

- Again, use a clamp to secure the hose in place.

Step 4: Connect the Return Jet to the Filter

After the pump has cleaned and filtered the water, it will return it to the pool through a return jet. Here's how to connect it to the filter:

- Attach a flexible hose to the discharge port of the pool pump.

- Connect the other end of the hose to the return jet located on the side of the pool.

- Secure the hose in place using clamps.

Step 5: Turn on the Pool Pump

After connecting all the necessary components, turn on the pool pump and check for leaks. If it runs silently and no water is escaping, congratulations, you have successfully connected the pool filter! Always make sure to prime the pump and clean the skimmer basket regularly to ensure proper water circulation and cleanliness.

Conclusion

Connecting the pool filter is not as daunting as it initially seems, and you can do it yourself. Just remember to familiarize yourself with your pool filter system, double-check all connections, and then turn on the pump, and you are good to go. Enjoy a clean and refreshing swim in your beautifully filtered pool, knowing that you successfully connected the filter system yourself.