how to bleed air from pool filter

Author: Poolking - Swimming Pool Equipment Manufacturer

How to Bleed Air from Pool Filter

Owning a swimming pool is a luxury that most people dream of, it provides endless hours of fun and relaxation during hot summer days. Maintaining a pool, on the other hand, can be quite a task. One of the most important aspects of pool maintenance is the filtration system. Without proper filtration, pool water can become cloudy or contain harmful bacteria that can make swimmers sick. A pool filter works by trapping dirt, debris, and other impurities from the water. However, sometimes air can become trapped in the filter causing it to malfunction. In this article, we will guide you on how to bleed air from a pool filter to ensure that your pool water stays crystal clear.

What causes air in pool filter?

Subheading: Understanding the Cause of Air in a Pool Filter

Before we delve into how to bleed air out of a filter, it's important to understand the cause of air in a pool filter. There are a few reasons why air might be trapped in your pool filter. One of the most common causes is when your pool pump draws in air from a damaged or faulty pipe. Another reason could be due to a clog in the suction line or an issue with the o-ring in the lid of the pump. A leak in the pool valve or filter can also let air enter the system.

How to Bleed Air from a Pool Filter

Subheading: Step by Step Guide on How to Bleed Air from a Pool Filter

Bleeding air from a pool filter is a relatively straightforward process that can be performed in a few simple steps. Read on to learn how to get it done:

Step 1: Turn Off The Pool Pump

Before starting with the process of bleeding air from the pool filter, you must turn off the pool pump. This will ensure that you can safely handle the pool equipment and prevent any accidents.

Step 2: Locate the Air Relief Valve

Next, locate the air relief valve on top of the pool filter. This valve is typically located near the filter pump, and it's a little knob that can be turned counterclockwise to release air.

Step 3: Open the Air Relief Valve

With your pool pump turned off, you can now open the air relief valve. Turn the knob counterclockwise slowly to allow air to escape from the filter. Listen for the hiss of air as it escapes.

Step 4: Water Should Start to Flow Out of the Valve

As air escapes through the valve, water should start to flow out. Allow the water to flow freely until you see a steady stream of water coming from the valve.

Step 5: Close the Air Relief Valve

Once water starts coming out of the valve, close it up. Don't over tighten the valve. You just need to close it enough to seal it to regain the air pressure necessary for the filter to function.

Step 6: Turn the Pump Back On

Turn on the pool pump and wait for a few moments. The pump should start functioning correctly, and water should run steadily through the filter without any air in it.

Other Tips for Preventing Air in Pool Filters

It is crucial to maintain your pool filter equipment properly to prevent air from getting trapped in it. Here are some tips that might help:

1. Regularly check the pool equipment and plumbing for leaks or cracks.

2. Clean the filter regularly to avoid any clogs in the suction line.

3. Replace the pump lid O-Ring or gasket when damaged.

4. Run a hose over any pipe connections to check for bubbles or leaks.

Endnote:

Bleeding air from a pool filter might sound like a stressful process, but it's more straightforward than you imagined. With these simple steps and equipment, you can get your pool filter working correctly, and your pool water will be crystal clear! Don’t forget to follow the maintenance tips to keep the process from happening all over again. Happy swimming!