how to install intex easy set pool filter

If you've purchased an Intex Easy Set pool, then congratulations! You're about to enjoy endless hours of fun in the sun. But before you can dive in, you'll need to make sure that your pool water is clean and clear. This is where the Intex Easy Set pool filter comes in. In this article, we'll show you how to install the Intex Easy Set pool filter so that your pool stays sparkling clean all summer long.

Getting Started: What You'll Need

Before you begin the installation process, there are a few things you'll need to gather:

- Intex Easy Set pool filter

- Filter cartridge

- Pump

- Hoses (if not included with your filter)

- Sand (if using a sand filter)

- Teflon tape

If you've purchased the Intex Easy Set pool filter kit, then everything you need should be included. If not, double-check that you have all the necessary components before you start.

Step 1: Choose a Location for Your Filter

The first step in installing your Intex Easy Set pool filter is to choose a location for it. Ideally, this should be somewhere close to your pool, but not directly next to it. You'll also want to make sure that the location is level and secure, as the filter can be quite heavy.

Step 2: Assemble the Pump and Filter

Once you have your location picked out, it's time to assemble the pump and filter. Connect the pump to the filter according to the manufacturer's instructions. Make sure to use Teflon tape to seal any connections and prevent leaks.

Step 3: Connect the Hoses

Next, you'll need to connect the hoses to the pump and filter. If your kit came with hoses, then these should be pre-sized and ready to go. If not, you'll need to measure and cut the hoses to the appropriate length.

Attach one end of the hose to the suction port on the side of the pool and the other to the inlet port on the pump. Then, attach another hose from the outlet port on the pump to the inlet port on the filter. Finally, connect a third hose from the outlet port on the filter back to the pool's return port.

Step 4: Install the Filter Cartridge

If you're using the Intex Easy Set pool filter cartridge, then this step is easy. Simply insert the cartridge into the filter housing and secure it in place according to the manufacturer's instructions.

Step 5: Add Sand (If Using a Sand Filter)

If you're using a sand filter, then you'll need to add sand to the filter housing. Consult the manufacturer's instructions for the appropriate amount of sand to use.

Step 6: Prime the Pump

Once everything is connected and secured, it's time to prime the pump. This will prevent air from getting into your filter system and help your pump run smoothly. To prime your pump, turn it on and fill the filter housing with water through the top. Once the housing is full, turn off the pump and let it sit for a few minutes to allow the water to settle.

Step 7: Turn on the Pump and Test the System

Finally, it's time to turn on the pump and test your new filter system. Check for leaks and make sure that water is flowing freely through the hoses and filter. Once you're satisfied that everything is working properly, go ahead and dive into your sparkling clean pool!

Conclusion

Installing the Intex Easy Set pool filter may seem daunting at first, but with a little patience and some basic tools, you can have your filter system up and running in no time. By following these simple steps, you can ensure that your pool stays crystal clear and ready for summertime fun.