how to change intex pool filter cartridge

How to Change Intex Pool Filter Cartridge

Having a pool in your backyard is great, especially during the hot summer months. However, it's important to keep the pool clean and safe for swimming. One of the most important components of every pool is the filter. In an Intex pool, the filter cartridge cleans the water by filtering out dirt and debris. But how do you change the filter cartridge when it's time to do so? Here's everything you need to know:

1. When It's Time to Change the Filter Cartridge

The filter cartridge in an Intex pool should be changed every two weeks, especially if the pool is used frequently. If you notice that the water is cloudy or the flow of water seems weaker than usual, it's probably time to clean or replace the filter cartridge. Keep in mind that the filter cartridge should be replaced if it has been in use for more than six months, even if it still looks clean.

2. Get the Right Replacement Cartridge

Before you start the process of changing the filter cartridge, you need to get the correct replacement cartridge. The Intex filters are available in different sizes and shapes, so make sure to get the one that matches your pool's model number. You can find this information on the pool packaging or in the owner's manual.

3. Turn Off the Pump

Before you start working on the filter cartridge, make sure to turn off the pump. This is important for your safety and to prevent damage to the pump. Unplug the power cord and wait a few minutes for the pump to cool down before you start working on the filter.

4. Remove the Filter Cartridge

Open the filter housing unit to access the filter cartridge. Remove the old filter cartridge by pulling it out of the housing. Be careful not to damage the housing while doing this. If the filter cartridge is stuck, you can use a wrench to loosen it.

5. Clean the Filter Housing

After you remove the old filter cartridge, clean the housing unit thoroughly. Use a hose to rinse any debris, dirt or other particles that might be stuck inside the housing. Make sure it is clean and dry before you install a new filter cartridge.

6. Install the New Filter Cartridge

Insert the new filter cartridge into the housing unit. Make sure it is properly aligned with the housing and fits securely in place. Check that the O-ring seal is in place to prevent any leaks.

7. Close the Filter Housing Unit

Once you have installed the new filter cartridge, close the housing unit. Tighten the clamps or screws evenly, but do not over-tighten them. This could damage the housing unit and the filter cartridge.

8. Turn on the Pump

After you have installed the new filter cartridge, it's time to turn on the pump. Plug in the power cord and turn the pump on. Check that the water is flowing through the filter and back into the pool properly.

Conclusion

Changing the filter cartridge in an Intex pool should be done every two weeks. It's important to use the right replacement cartridge that matches your pool's model number. Remember to turn off the pump, remove the old filter cartridge, clean the housing unit, install the new filter cartridge, and close the housing unit properly. Once you have completed these steps, turn on the pump and check that the water is flowing correctly. By following these simple steps, you can keep your Intex pool clean and safe for swimming.