how to drain jandy pool filter

How to Drain Jandy Pool Filter: A Step-by-Step Guide

Jandy pool filters are an essential part of any pool’s filtration system. They help keep the pool water clean and clear by trapping dirt, debris, and other contaminants. However, like any other filtration system, Jandy pool filters need periodic maintenance and cleaning to work effectively. One of the critical steps in maintaining your Jandy pool filter is to properly drain and remove water from it. In this article, we’ll guide you through how to drain your Jandy pool filter in five easy steps.

Step 1: Turn off the Pool Pump

Before you begin to drain your Jandy pool filter, make sure to turn off the pool pump. This step is vital to avoid any potential accidents or damages. Shutting off the pool pump will stop the water flow from your pool into the filter, which is necessary to drain the water properly.

Step 2: Turn Off the Power Supply

After turning off the pool pump, it’s equally essential to switch off the power supply of your pool filter. This step is necessary for your safety, especially if you’re dealing with an electrical pool filter. To turn off the power supply, go to your pool equipment panel and locate your pool’s filtration system breaker. Then, turn off the power supply of the pool filter by flipping the switch.

Step 3: Open the Drain Valve

Once you’ve turned off the pool pump and power supply, it’s time to open the drain valve. The drain valve of the Jandy pool filter is usually located at the bottom of the filter tank. To open the drain valve, you can use a wrench to loosen the nut or handle. After loosening the nut or handle, be ready to catch the draining water using a bucket or hose.

Step 4: Clean the Filter Tank

While you’re draining the water, use this opportunity to clean the filter tank of your Jandy pool filter. Use a hose to scrub the filter tank’s interior, including its laterals or grids, to remove any dirt, debris, or buildup that may have accumulated inside. You can also use a filter cleaner or degreaser to help break down any built-up greases or oils.

Step 5: Close the Drain Valve and Refill the Filter

After cleaning the filter tank, you need to close the drain valve and refill your Jandy pool filter with water. To refill the Jandy pool filter with water, you can use a garden hose, but make sure to stop filling once the water level reaches the halfway point of the filter tank. Leaving enough space for air will help prevent any potential damage caused by high-pressure water flow.

Conclusion

Successfully draining your Jandy pool filter is essential in keeping your pool’s filtration system working effectively. Remember to turn off the pool pump and power supply before opening the drain valve. Clean the filter tank thoroughly while draining the water, then close the valve and refill your Jandy pool filter with water. By following these five simple steps, you’ll be on your way to enjoying cleaner, clearer pool water all year round.