Common faults and troubleshooting methods of ultraviolet sterilizers

Today's ultraviolet sterilizers are already more and more widely used in the water treatment industry. However, the products with good and bad products in the market often make it difficult for many customers to judge, buy defective products unintentionally, and frequently replace ultraviolet parts. The following methods are to teach you to do some basic fault detection and troubleshooting methods. Boying recommends that you choose a regular manufacturer in order to better relieve your worries! Common faults and troubleshooting methods of ultraviolet sterilizers: troubleshooting method 1. Water leakage at the end of the quartz tube 1. The quartz tube is broken; 2. The end gland is not tightened; 1. Replace the quartz tube; 2. Tighten the gland screw evenly until no water leaks, do not tighten too tightly 2. Low sterilization efficiency 1. Voltage Low; 2. Attachments on the outer wall of the quartz tube; 3. The radiation intensity of the lamp tube is lower than 70U 1. Adjust the voltage 2. Clean the quartz tube 3. Replace the lamp tube 3. The indicator light and the lamp tube are not bright 1. The melting wire is blown; 2 .The socket of the lamp tube is not inserted firmly; 3. The plug inside the socket is broken; 4. Whether the ballast is damaged; 5. Whether the light-emitting diode is damaged; 6. Whether the bridge is damaged; 7. Whether the signal transformer is damaged; Replace the melting wire; 2. Insert the socket firmly 3. If the insert is desoldered, resolder it firmly 4.5.6.7. If damage is found, it must be replaced Poolking is the best swimming pool equipment manufacturer and supplier in China. Poolking exists to provide the highest quality swimming pool equipment while offering competitive pricing..