how to replace pressure gauge on pentair pool filter

Author: Poolking - Swimming Pool Equipment Manufacturer

How to Replace Pressure Gauge on Pentair Pool Filter

As a pool owner, you know that proper maintenance is required to keep your pool water clean and clear. One of the most essential parts of your pool system is the filter, which removes dirt, debris, and other contaminants from the water. Pentair pool filters are a popular choice among pool owners due to their effectiveness and durability. However, over time, the pressure gauge on your Pentair pool filter may malfunction or break, making it challenging to keep track of the filter's pressure. If the pressure gauge stops working, it's essential to replace it promptly to avoid potential pool problems. In this article, we will guide you on how to replace the pressure gauge on your Pentair pool filter.

1. Gather the Required Tools and Parts

Before you start the process of replacing the pressure gauge, be sure to gather all the necessary tools and parts. This will help you avoid running back and forth, reducing the time to complete the replacement. You will need the following:

- A new pressure gauge that is compatible with the Pentair filter

- A wrench set

- Teflon tape

- Pliers

2. Turn Off the Pool's Filter System

Before opening up the filter, make sure to turn off the pool's filter system. This will ensure that no water is circulating through the system while you are working on it.

3. Open the Filter's Air Bleed Valve

Next, open the filter's air bleed valve, which is located on top of the filter. This valve releases the pressure from the filter, lowering the risk of accidents while opening up the filter.

4. Remove the Old Pressure Gauge

Using the wrench set, remove the old pressure gauge from the filter by turning it counterclockwise. Be careful not to use too much force as you may damage the filter.

5. Apply Teflon Tape

Wrap some Teflon tape around the threads of the new pressure gauge. This will create a tight seal when you install it onto the filter.

6. Install the New Pressure Gauge

Screw the new pressure gauge onto the filter by turning it clockwise using the wrench set. Use pliers to hold the back of the pressure gauge while tightening it.

7. Turn the Filter System Back On

After installing the new pressure gauge, turn the pool's filter system back on and wait for a few minutes to let the water circulate through the filter.

8. Check the Pressure Gauge

Check the new pressure gauge to make sure that it is reading correctly. If it's not, repeat the process until you obtain a correct reading.

Conclusion

Replacing the pressure gauge on Pentair pool filter is an easy and straightforward process that can be done quickly by following the above steps. Keeping an eye on the pressure gauge is vital to monitor the efficiency of the filter and avoid potential pool problems. By replacing the pressure gauge when it fails, you can ensure that your pool's filter system runs efficiently for years.