how to put sand in pool filter

Author: Poolking - Swimming Pool Equipment Manufacturer

Are you tired of maintaining your pool every now and then? Well, one of the key components of maintaining a pool is the pool filter. A pool filter is responsible for filtering out all the impurities in the pool water to keep it clean and safe for swimming. As dust, dirt, leaves, and other debris accumulate in the pool, the filter might not be enough to do its job, that's when you add sand to your pool filter. This article will teach you how to put sand in your pool filter.

Why replace the sand in the pool filter?

The sand in the pool filter is not meant to last forever. After a while, it becomes worn out and can no longer trap small particles as it should. Replacing the sand in your pool filter is crucial to ensure that it works to its fullest potential.

Materials needed to replace the sand in your pool filter

Before you begin replacing the sand in your pool filter, you need to have the necessary tools and materials. Here are the items you'll need:

- New sand

- Screwdriver or wrench

- A cup or scoop

- Teflon tape

- A shop vac

- Water

Steps to replace the sand in your pool filter

1. Drain the filter

Before unscrewing the filter, ensure to drain all the water from the filter. This step will prevent you from carrying extra weight while carrying it.

2. Open the filter

Using a screwdriver or wrench, remove the bolts that are keeping the filter closed. Ensure you keep this parts safe as you will need them when closing the filter.

3. Remove the old sand

Carefully remove the old sand from the filter. Use a shop vac to remove the finer sand that might have stuck in the laterals- this is the small pipes in the bottom of the filter.

4. Inspect laterals

Inspect the laterals for any signs of wear and tear. If you notice any damages, replace them.

5. Add the new sand

Finally, add the new sand to the filter using a scoop or cup. Be careful not to pour too much sand at once. It is recommended to fill the filter halfway and then add water to level the sand.

6. Tape the seal and close the filter

Using Teflon tape, seal the filter cover, screw on the cap and bolts, then tighten using a screwdriver or a wrench.

7. Backwash the filter

Backwash the filter for about five minutes. This process will remove the fine particles from the new sand to avoid them from entering the pool. Continue running the filter until you notice clean water coming out.

Final Thoughts

Maintaining your pool filter is crucial as it contributes significantly to the quality of your pool water. Replacing the sand in your pool filter is one of the ways to ensure that it works to its fullest potential. Ensure to follow the steps mentioned in this article, and you'll be on your way to cleaner, safer water for swimming.