how to backwash summer waves pool filter

Author: Poolking - Swimming Pool Equipment Manufacturer

How to Backwash Summer Waves Pool Filter

Summer is here, and it's time for trips to the beach, spending time with family and friends, and of course, taking a refreshing dip in the pool. Having a pool is one of the best ways to beat the summer heat, but it's important to keep it clean and well-maintained so you can enjoy it for years to come. A vital part of pool maintenance is backwashing your pool filter, and in this article, we'll show you exactly how to do that for a Summer Waves pool.

Understanding Your Pool Filter

Before we dive into the specifics of backwashing, it's essential to understand a little bit about the pool filter. In general, there are three types of pool filters: sand, cartridge, and diatomaceous earth (DE). Summer Waves pools generally come with a sand filter, but the same basic principles apply to all types of filters.

The purpose of the filter is to remove dirt and debris from your pool water, and over time, that debris accumulates inside the filter, making it less effective. That's where backwashing comes in. When you backwash your pool filter, you essentially reverse the flow of water through the filter, flushing out all the dirt and debris and giving your filter a fresh start.

Getting Started: What You'll Need

Before you start backwashing, you'll need a few tools:

- A garden hose

- A clean bucket

- The owner's manual for your Summer Waves pool

The owner's manual will have specific instructions for your pool model, so be sure to have it handy.

Preparing Your Pool Filter for Backwashing

Step 1: Turn off your pool pump. You never want to backwash your pool filter while the pump is running because that can damage the filter and the pump.

Step 2: Locate your pool's filter. In most Summer Waves pools, the filter is located near the pump. Look for a container with a pressure gauge and a handle on the top.

Step 3: Turn the handle on top of the filter to the "backwash" position. The handle may be labeled, but refer to your owner's manual if you're not sure.

Step 4: Attach your garden hose to the backwash port on the filter. This port is usually located on the side of the filter and may be labeled.

Step 5: Place the other end of the garden hose in the clean bucket. You will see dirty water coming out of the hose, which is why you need the bucket.

Backwashing Your Pool Filter

Step 1: Turn on the pool pump. Now that everything is set up, turn your pump back on.

Step 2: Let the water run for about two minutes. You will see dirty water coming out of the garden hose and into the bucket.

Step 3: Turn off the pool pump. After about two minutes of backwashing, turn off your pump again.

Step 4: Move the handle back to the "rinse" position. This step is important because it cleans the filter before returning to normal operation. Be sure to refer to your owner's manual for specifics on how long to rinse.

Step 5: Turn on the pump again and let it run for a few minutes. This will rinse the filter and ensure it is ready for normal use.

Finishing Up

Congratulations, you've successfully backwashed your Summer Waves pool filter! Be sure to refer to your owner's manual for specifics regarding how often to backwash your filter (it generally depends on how often you use your pool). A good rule of thumb is to backwash your filter every time the pressure gauge reaches 8-10 PSI above the "clean" reading.

By properly backwashing your filter, you will extend the life of your pool equipment, improve the overall quality of your pool water, and enjoy many summers of fun in the sun.